![]() ![]() The access point’s IP address is optimally provided using DHCP. Up and running and access management functions:ġ. Once the AP-6521 is installed and powered on, complete the following steps to get the access point Here are the instructions straight from the install manual. There is a zero config option that does not require the AP to be on your network, and it is always on. To do this, press and hold the reset button for more the 5 seconds.This clears the access points user settings, including User ID, Password, IP Address, and Subnet mask.Īfter the access point is reset to factory default, re-verify the Ethernet connectivity and IP address issues. If you think you have changed the IP address used to configure the access point and cannot remember it, you must reset the unit back to factory defaults. The default is http:/ Opens a new window / 192.168.40.1 Opens a new window. Verify you are entering the correct URL in the browser. If you have changed the factory configured default IP address of the access point, you will need to set your network adapter accordingly. ![]() ![]() In the Command window, type ping and your access points default IP address and press Enter. Verify that you can ping the access point on this IP address. The IP address of your network adapter must be on the same network and not a duplicate of any others on the network (for example: 192.168.40.10 and using a subnet mask of 255.255.255.0 can be used to login to the access points default IP address of 192.168.40.1). Verify that the IP address of the PC being used to configure the access point is on the same network as the access points configuration IP address. Verify your Ethernet connection to the access point. Hold the Reset button for more than 5 seconds. While the access point is powered, press and To reset the access point to the factory defaults, ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |